Baglama mold

Mold dimensions:
Length: 155mm
Width: 92mm
Height: 65mm

Warning! The dimensions above refer to the mold and not to the speaker that is going to be build on it. Obviously the speaker's dimensions will be a little bigger than the mold's depending on the wood slices that you use for the speaker.

The mold is not assembled! To assemble the mold you will need titebond glue and a few pieces of wood to reinforce some areas.
The construction material is 4mm plywood.

The staves design and creation has to be done from the customer. We do not provide any information about the stave construction proccess. Making the right staves is a difficult procedure and need a lot of time especially for amateurs.

Directions of assemble are provided into the video that follows.